SEFIRE · Technical guides

Electric Fireplace Selection and Installation

Separate the visual effect from any heater and check the actual electrical rating.

How much electricity and heat does it use?

Use the nameplate input for the selected operating mode. Energy in kWh equals input in kW multiplied by operating hours; multiply by your tariff for cost. A visual-only mode and heater mode differ. Room heat demand also depends on climate, insulation and heat loss, so floor area alone cannot establish adequate heating or whole-house savings.

What does a fireplace wall or country-house installation need?

Confirm approved recess dimensions, wall support, supply circuit, air inlets, heat outlet and service access. Keep the heater outlet and specified combustible clearances clear. Check voltage, indoor conditions and seasonal dampness. Holographic, optical and mist effects use different equipment; a legacy SE-HOLO name does not establish that a current EVFP model has the same heater or dimensions.

Can an electric fireplace catch fire or burn real wood?

Electrical equipment can fail or overheat if damaged, covered or installed incorrectly. Follow the supply and heater instructions, keep combustible items clear and do not leave a heater operating unattended. Never burn wood, gel or ethanol inside an electric visual fireplace. Its decorative logs and enclosure are not a wood-burning firebox.

How can the effect look natural and what causes noise?

Compare a demonstration in normal room lighting, from your viewing angle and with sound. Enclosure depth and visible reflections affect realism. A fan, motor, pump or water movement can produce sound depending on technology. New grinding, rattling or excessive noise needs inspection after safe shutdown; do not lubricate or dismantle internal components without service instructions.

Related guides

Project inquiry

Technical guides